solutions

Autonomous Start System

ThermaStart

Immediately reduce operating costs and increase reliability of your fleet. Our easy to install, simple solution allows the engine to shut off while we monitor battery, engine temperature and air pressure conditions. When these conditions fall out of spec the ThermaStart will sound a warning and start the truck, running a warm-up and fast idle cycle until conditions are restored and then going back into standby mode. One of the fastest ways and easiest ways to increase operational and maintenance efficiencies. The system is non-invasive to the OEM controls , ECM is in full control of engine management. The ThermaStart Solution contributes significant reductions in GHG's, fuel consumption, maintenance and engine replacements with an immediate..

Read More
engine-img engine-img

Engine Start Module

Ultra-Capacitor ESM Kits

The Skeleton ESM has the highest Power density on the market with 15+ year life expectancy. The ESM replaces batteries for engine starting. Never boost again, full power at -40C and auto-charging even from "dead batteries". Delivers a ton more power than batteries for starting. Increase battery, starter and alternator life. Restores balance to the eletrical circuit by eliminating severe starting and charging loads which cause high and low peaks. Capacitors are much safer and reliable and come with a 6 year / 1Million cycle warranty.

Read More
engine-img engine-img

Mining Heaters

Playford Heaters

The Playford mining heater has been the choice of OEM's for decades. Common to both Komatsu and Caterpillar Electric shovels and drills the Playford heater will be found in any mine operating in cool conditions. Rosco Mining Solutions is an exclusive distributor of the Playford heater to mines all over North America. We're happy to quote you for your next planned replacements.

Read More
engine-img engine-img

Large Cabin Filtration

RMS-200 Pressurizer and Filtration System

The RMS200 was made for shovels, drills, excavators and draglines. 3 stage filtration and mine proven reliability. Available in 24V, 115V or 230V. Quick and easy to install, the RMS200 replaces your original system with a simpler and higher performance solution. It can be easily adapted to cabs without current pressurization.

Read More
engine-img engine-img

Centrifugal Oil Filters

Glacier Centrifuges

The glacier centrifuge has been trusted by some of the worlds largest engine manufacturers as the ultimate in oil protection. We have several mining specific applications which extend the life of your oil, engines, pumps and components. Install once for life and enjoy the status of world-class asset management. The Centrifuge protects your engine from grit and soot left behind from filters. It offers the highest level of protection and quality for your oil. Glacier centrifuges are also used in hydraulic oil circuits. Contaminants are transformed into solid waste for disposal or analysis. Traditional oil sampling allows you to SEE contaminants trapped in your oil, The Glacier centrifuge allows you to HOLD them.

Read More
engine-img engine-img

Magnetic Scrubbers

Glacier Magnetic Scrubbers

An awesome bolt on solution which drastically increases component life and prevents unnecessary wear. Maintenance is super easy, just remove the magnetic rod, wipe with a rag and you’re done. The magnets are so powerful that they pull both ferrous AND non-ferrous materials from the oils. They do not cause a restriction and therefore can even be placed in the suction side of a pump for protection. Work with high viscosity oils as well.

Read More
engine-img engine-img

HVAC Maintenance Training

Parts, Systems and Training

We are experts when it comes to air conditioning, heating and filtration of mobile mining equipment. From dozers to shovels HVAC maintenance is our specialty. Rosco is trusted to support several mines and large fleet operators with technician training, continuous improvement programs and custom hvac sytems.

Read More
engine-img engine-img

Air Starters

Air Starters

The ST1000 Series offers some of the highest torque at low pressure, delivering a superior reliability in starting. They are more resistant to corrosive and dirty air, require no soft-start valve and rebuild for a fraction of the cost of the competitor and less often. We will gladly help you set-up a system on the trucks for you to validate the superior performance for yourselves.

Read More
engine-img engine-img
solution
Applications
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img

ESM 244 for 50L-65L Engines

Features: 4 X 24V ESM – 4700 CCA’s

Equipment: Haul Trucks, Loaders, Dozers, Excavators, Drills

Engines: 50L to 65L displacement Engines

Application: Komatsu 930 with QSK60

Read More product-image
house-heaters-img
house-heaters-img
house-heaters-img
house-heaters-img

RMS200 – 495 Shovels

Solution: RMS200-495-KIT

Features: Dual 200CFM 110V System with Cab upgrades

Equipment: Caterpillar / Bucyrus 495 HD & HF & HR

Read More product-image
house-heaters-img

ASW – 44.00 R57

Caterpillar 793

Komatsu 830

Hitachi 4000/4400

Unit Rig 4000-4400

The ASW404057 can be matched to the above trucks.

Read More product-image
projects